How does the Wi-Fi controller connect with Paneralux App?

 

PaneraLux controllers are pre-configured to the corresponding light modes before shipping. Example: if you've purchased RGB pool light strips, the controller you receive is already set to RGB mode. You can start from step 3 to complete the connection between the controller and the App.

Wi-Fi controller and App connection method:

A.Enable Bluetooth on your phone and connect to 2.4GHz Wi-Fi. Download the PaneraLux App via the QR code on the controller and complete the registration to access the app's home page.

B.The connection steps between the Wi-Fi controller and the app are as follows: Set the controller to either single-color or RGB mode, enter pairing mode, and then pair with the app. Note: The controller indicator light in white indicates white & blue light mode, and in red indicates RGB mode.

Using RGB controller as an example:

  1. Long-press the button on the controller; after 3 seconds, the indicator light will go off and then light up in purple.
  2. Keep pressing without releasing to enter the light mode selection. The indicator light will cycle through white-yellow-red-green-blue lights. Release the button when the indicator light turns red. The indicator light will flash purple light twice and then stay red. Then the controller enters RGB mode.
  3. Quickly press the controller button twice, and both the indicator light and the light strip will rapidly blink purple. The controller enters pairing mode.
  4. On the app's home page, click "Add device" to enter a new page. Under "discovering devices," click "Add" and then click "+" to select the controller. (At this point, a Wi-Fi connection page will appear. Input your home Wi-Fi information; 5G Wi-Fi is not supported at this time.)
  5. Wait a few seconds for the controller and app to successfully connect. (If the connection fails, you can click to reconnect.)

 

Our app can control 2 or more Wi-Fi controllers at the same time, the steps are as follows:

  1. Follow the steps above to pair all controllers with the App.
  2. Rename each controller for easy operation. Click the paired controllers to enter the single controller interface, click the Edit button on the upper right corner to change the controller name, for example: "controller A", “controller B”, “controller C”…etc
  3. Enter any controller interface, find "Create Group" in the upper right corner of the editing page, add all the paired controllers successfully and save it.
  4. Enter the group interface, you can synchronize all the paired controllers.