How to cut and seal garden decorative lights?

This garden decorative light strip supports cutting, every 6 led beads/100mm can be cut. The specific operation is as follows:

1. Confirm the length to be cut. Please note that the minimum cutting length of the light strip is 10cm.
2. Find the two horizontal rows of copper soldering discs on the strip, and take this as the cutting point to cut.
3. Light up the strip to make sure that there is no dead light or lack of color after cutting.
4. Insert the anti-spill plug into the cutout and make sure it is fully embedded in the cutout of the strip.
5. Squeeze the silicone adhesive inside the sealing plug to ensure that the sealing adhesive completely fills the inside of the plug.
6. Plug the cut end of the strip into the sealant-filled tail plug and allow to cure at room temperature for 24 hours.

It should be noted that the length of a single strip of the RGB/RGBW version after cutting cannot exceed 15 meters, otherwise there will be color difference when brightening white light.